Assembly Instructions for Power Supply
Front Plate
Install the front plate by aligning the edges of the plate with the groove in the base casing. At some times, this can be hindered and may required that the base be cleaned prior to insertion.
Back Plate
Instal the back plate using a similar procedure.
Circuit Board
The circuit board is installed carefully using a anti-static mat.
Fan
Position the fan just inside the front plate.
Fan Screws
In stll the fan using four (4) 1" screws.
Power Receptacle
The power receptacle is installed onto the front plate.
Power Receptacle Screws
Use two (2) 1/2" screws to mount the power receptacle.
IO Board
Install the IO board by snapping the 16 pin connector onto the circuit board at position market "AM".
Thumbscrews
Install all of the thumbscrews by solderiing them to the IO board behind the back panel. These should be installed by a expert solder technician.
Fan Cable
Power Cable
Solder the power cable to the power receptacle and connect the 3x7 pin power connector to the sircuit board as shown.
Top Cover
Install the top cover by snapping it into place properly with the front and back panels.
Power Supply
The assembly procedure is complete.
# | Name | Quantity |
---|---|---|
1 | PACTEC_CM5-125 | 2 |
2 | PCB | 1 |
3 | 144 PIN IC PACKAGE | 2 |
4 | Heatsink | 2 |
5 | 111 | 6 |
6 | 222 | 1 |
7 | 333 | 4 |
8 | pt | 2 |
9 | CAP | 6 |
10 | Power-Receptacle | 1 |
11 | pabst 512f | 1 |
12 | Back Plate | 1 |
13 | Front Plate | 1 |
14 | dc-red | 4 |
15 | dc-black | 4 |
16 | Pan Head Cross Recess Screw_DIN | 4 |
17 | Countersunk Flat Head Cross Recess Screw_DIN | 2 |
18 | pabst 512f blade | 1 |
19 | connector (3pin) male | 2 |
20 | connector (3pin) female | 1 |
21 | Cable-routeAssy1-DCPSU | 1 |
22 | 436801003 | 1 |
23 | Cable-RouteAssy6-DCPSU | 1 |
24 | IOBoard | 1 |
25 | LID3 | 1 |
26 | LID4 | 1 |
27 | Lid5 | 1 |